Wi-Fi Car / NodeMCU
Install Weryt's tested firmware for an ESP8266-based car. The firmware binary and manifest must match your exact board and wiring.
Installer is not live until the placeholder manifest is replaced with tested firmware.
Welcome to Weryt Solutions
Upload your project.
Skip the IDE setup.
Choose the correct board and install firmware supplied by Weryt. Connect your board to a Windows computer with a USB data cable and follow the prompts. You do not need to install Arduino IDE.
1
Connect the boardUse a USB data cable. A charge-only cable will not work.
2
Choose the exact boardDo not install ESP8266 firmware on an ESP32 or Arduino board.
3
Click Connect & InstallChoose the serial port and keep the board connected until it finishes.
Select your board
Firmware installation becomes active once Weryt publishes tested firmware builds.
ESP8266 / NodeMCU
For other ESP8266 projects. Use only the firmware supplied for the specific Weryt kit.
Firmware manifest needs a real, tested binary before use.
ESP32 projects
Browser-based flashing for compatible ESP32 boards and precompiled firmware.
Manifest must point to a correctly merged ESP32 firmware binary.
Arduino UNO / Nano
Classic UNO/Nano boards require a separate AVR-compatible uploader. They cannot be flashed by the ESP installer shown above.
We'll implement this separately after confirming exact board and bootloader variants.
Safety and compatibilityFlashing replaces the current program and may erase settings. Use the correct firmware for your exact board. Disconnect motors and external motor power while programming where practical; reconnect power only after checking wiring. Never power motors from the ESP8266's 3.3 V pin.